How to Replace Wood Floor Boards

Have you ever had concerns about a damaged hardwood board in your house and you don’t have a professional to fix it? You are not the only person. Everyone who has a hardwood floor will certainly have to replacement a damaged board at some time. Board replacement is a common in the hardwood flooring industry.

Wooden Floor BoardsMost boards which need to be replaced are due to events which are out of our control, for instance: environmental factors, objects that fall shoes, damage from furniture, pets and children. A board replacement will make your flooring looking as if it was never damaged before and you won’t know that replacement has been done.

Here are the simple steps on how you can replace a damaged board in you flooring.

Tools needed for board replacement:

  • Circular Saw
  • Hammer
  • Chisel
  • Painters tape
  • Miter Box
  • Epoxy
  • Small pry bar
  • Painters plastic (used to prevent the furniture from dust exposure)

Step 1: Cover the bottom side of your circular saw using a blue tape so that it may not scratch your flooring. Set up the depth of the skill saw to match the thickness of the board you want to replace. Apply blue tape throughout the board that is being cut so that you do not accidentally cut into a different plank. Cut down the side of the board on the groove surface and on the tongue surface and then make an additional cut diagonally across the first two cuts you had made.

Step 2: Using a pry bar and a hammer, pull up the two halves in the center of the board. Chisel out the few remaining pieces that are stuck around the edges.

Step 3: Pull out the nails and cut out the rosin paper or the felt. Take a vacuum cleaner to clean any debris.

Step 4: using the #2080 painters tape, obtain the measurements of the area that was cut out.

Step 5: Measure the new board and cut it into desired lengths needed. Using a sanding sponge, create a slight bevel especially on the cut edge. Cut the bottom groove off the width and length of the board.

Step 6: Apply urethane adhesive to the cleaned sub floor in a snake like pattern. Place the new board in; sliding the tongue into place first. Use a block of wood to tap down gently and precisely on the new board. This will knock it in place.

Step 7: Apply some weight to the board until the adhesive cures. Use a cleaner to clean any debris.

You have now finished your board replacement! Very simple process indeed!

Here are installation tips that you have to put in mind before you conclude your work:

Tip 1: As a result of natural color changes in most wood species, the replaced board may not actually match the old flooring. If this is happens, let the new board sit in a spot where it will receive the most light for a week. Direct light quickens the color change which allows the new board to match with the old flooring in a better. This also helps the new board toughen to the new environment of the home.

Tip 2: Measure the sides of the old board to make sure that it is equal to the sides of the new board. If the old board has expanded, the new board will not fit. The board replacement should be adjourned until a drier climate.

Now that you know how to replace wood floor boards, make sure you also know how to pick the best wood floor coating. For more great tips on hardwood floors, hardwood floor vacuums, and cleaning wood floors in general, visit Homestadna. Good luck with your project!


Leave a Reply